Filter
Top Products
21
21
PROJECTION (PCR507W) Only
The Atomic Projection Clock is capable of projecting the information
immediately, as well as continuously.
IMMEDIATE PROJECTION
• Press SNOOZE/LIGHT button once to project the current time
image for five seconds.
• Press FLIP button to rotate projected image 180° clockwise
• Press and hold FLIP button for 2 seconds again and the
projected image will rotate between the time and indoor
temperature information every 5 seconds
CONTINUOUS TIME AND TEMPERATURE PROJECTION
• Connect AC/DC adapter provided to the AC adapter input
• Slide the CONTINUE PROJECTION switch to the arrow direction
shown on the unit’s side: the current time will be projected on the
wall or the ceiling continuously.
22
ALARM SETTING
The Atomic Clock Radio has two time alarms. If any of the alarms is
activated, it will sound at the set time and the alarm icon will flash. Also,
you can select the alarm in radio sound or beep sound by switching to the
desired position.
BELL ALARM SETTING
• Slide the alarm switch to the ALARM position. The alarm icons of
and will be shown on the display.
• Press MODE button to view the ALARM 1 or ALARM 2 modes.
If the ALARM 1 is selected, the default time “6:00” with the AL
label will be displayed. If the ALARM 2 is selected, the default
time”8:00”with the AL 2 label will be displayed
• Press and hold the MODE button for two seconds - the hour digit
will flash
• Enter the hour parameter by using DOWN or UP button
• Press the MODE button again, then the minute digits will flash
• Enter the minutes parameter by using DOWN or UP button
• Press the MODE button one last time to confirm the setting.
• Use the same procedure for setting the time for ALARM 2
RADIO ALARM SETTING
• Slide the alarm switch to the RADIO position. The alarm icons of
and will be shown on the display.
• Press MODE button to view the ALARM 1 or ALARM 2 modes.
If the ALARM 1 is selected, the default time “6:00” with the AL
label will be displayed. If the ALARM 2 is selected, the default
time”8:00”with the AL 2 label will be displayed
• Press and hold the MODE button for 3 seconds - the hour digit