Filter
Top Products
10 0702
FA 500.2
8. Malfunctions
Check the following before calling customer service:
• Is the power plug connected?
• Is the shredder switched on?
• Is there a paper jam in the shredder?
• Has the motor been overloaded?
Paper jam
You have fed in too much paper.
` The red LED on the keypad blinks.
` The cutting block automatically runs in
reverse for several seconds.
Caution!
The blade rollers can still cause injuries
even while they are not running.
Do not reach into the cutting apparatus!
Wear safety gloves!
• Take out the pile of paper.
• Press the green start button and put less
paper on the feed belt.
Electric motor overheated
` The red LED on the keypad lights up.
` The shredder switches off automatically.
• Let the motor cool down for 20 - 30
minutes
• Press the green start button.
Safety circuit interrupted
` The red LED on the keypad lights up.
` The shredder switches off automatically.
• Check
- Safety fl ap on the feed belt is closed.
- The dust tray is pushed in completely.
- (only stand alone-version)
The inspection door is closed.
- (only stand alone-version)
The protective fl ap is in vertical position.
• Press the green start button.
9. Maintenance and care
Cleaning the cutting unit if the cutting quality
deteriorates or the machine becomes noisy
• Let the shredder run without
feeding in any paper.
• Push the lever of the oiler
down several times.
• Make sure the oil level in
the container is between the
MIN and MAX markings.
Order no. 1.235.997.500 for
5 litre container
MIN
MAX
Paper dust and particles accumulate in the paper shred-
der during operation. To facilitate cleaning, the ground
plate of the paper shredder was designed as a tray. This
tray must be emptied every week.
Note:
The paper shredder cannot be switched on
unless the dust tray is fully pushed in.
Emptying the dust tray