Filter
Top Products
0702 9
FA 500.2
Safety switch on the inspection door (only
stand alone-version)
Open the inspection door.
The shredder must switch off immediately and the ”Safety
circuit interrupted” LED must light up.
The machine will only start again once you have closed
the inspection door.
Safety switch on the protective fl ap (only
stand alone-version)
Open the protective fl ap.
The shredder must switch off immediately and the ”Safety
circuit interrupted” LED must light up.
The machine will only start again once the protective fl ap
is in its basic (vertical) position.
• Press the green start button.
` The cutting block and feed belt start up.
• Place the material to be shredded on the
loading tray and then place batches on the
feed belt.
If material that is not supposed to be shred-
ded is mistakenly placed onto the belt, never
attempt to pull it out
• Press the stop button.
` The drive stops.
• Press the reverse button.
` The cutting block and feed belt run in
reverse.
• You can now remove the material from the
belt and start the shredder again by press-
ing the start button.
Stopping the shredder
• Press the stop button.
` The cutting block and feed belt stop.
` The shredder switches to standby mode.
Switching off the shredder
• Turn the main switch on the paper shred-
der or the baling press to 0.
You can secure the main switch in this
position using a padlock.
Shredding material