Filter
Top Products
A5
Setup Diskette for Windows 95/98
Monitor Installation Disk for Windows
®
95/98
To use the Plug and Play feature in Windows 95 or Windows 98, files should be
loaded from the IBM color LCD Monitor Installation diskette as follow:
Ensure that the monitor is connected correctly.
Turn on the monitor and then the system unit. Allow the system to boot into
windows 95 or 98. The Operating system’s Plug and Play code may advise
you that your system handware has changed. If this is the case,it means that
it has detected your new monitor for the first time.
Open the Display Properties windows by clicking on Start, Setting, Control
Panel and then double clicking on the Display icon.
Select the settings tab.
Select the Change Display type button.
Select the Change Monitor Type button.
Insert the setup diskette into drive A: and select the Have Disk button.
Select OK.
Choose IBM 9483 monitor and select OK.
The files will be copied from the diskette to your hard drive.
If the selected model name is correct, Close all open windows and take the
disk out from the disk drive.
Restart the system to activate the setting.
Note: On LCD monitors, unlike CRTs, a faster refresh rate does not improve display
quality. IBM recommends using 1024 x 768 at a refresh rate of 60Hz.
Windows 95 and 98 are Registered Trademarks of Microsoft Inc.
11
10
9
8
7
6
5
4
3
2
1