IBM 8191 Computer Hardware User Manual


 
6. Scroll down and look for a .txt file that has instructions for Flash BIOS update
from the operating system. Click the .txt file.
7. Print these instructions. This is very important since they are not on the screen
after the download begins.
8. From your browser, Click Back to return to the list of files. Carefully follow the
printed instructions to download, extract, and install the update.
Recovering from a POST/BIOS update failure
Attention: If an interruption occurs during a Flash/BIOS upgrade, the BIOS
might be left in an unusable state. The Boot Block jumper enables you to restart
the system and recover the BIOS.
To perform a Flash/BIOS recovery using the recovery jumper, use the following
procedure.
1. Power-off the computer and remove the cover.
2. Move the system board recovery jumper to the clear position. Refer to
Identifying parts on the system board on page 25 or the label inside the
computer for more information.
3. Place the cover back on the system.
4. Place the BIOS flash recovery diskette in the floppy disk drive.
5. Restore power to the system by plugging in the power cord.
6. During the recovery process, there will be a sequence of short beeps. This
sequence of beeps will be followed by a single long beep and then silence
from the system speaker. During this process there will be no video. After the
last long beep, hold the power button in for approximately ten seconds to
turn the system off.
7. Remove the BIOS flash recovery diskette, power cord and cover.
8. Return the boot block recovery jumper to its original position, replace the
cover and reinsert the BIOS flash recovery diskette in the floppy disk drive.
9. Connect the power cord back to the system and power the system on. When
the system POST tests, it will report several POST errors. These errors can be
ignored. The standard POST/BIOS Update Utility screen will appear after a
pause.
10. Select the desired language from the list and press Enter.
11. Enter the serial number of the system and press Enter.
12. Enter the Machine Type and model number of the system and press Enter.
13. If a prompt appears stating that the BIOS ROM is older than (or the same as)
the BIOS ROM image, press Y to continue.
14. When the flash programming is complete, remove the diskette from the drive
and press any key to restart the system.
114 Hardware Maintenance Manual