Filter
Top Products
23
ENGLISH
9. Press one of the contrast control buttons. The messages are
automatically displayed in the following sequence : ‘OFF-READY-
START-COMPLETED’ and auto setup is complete.
10. Press the setup switch on the back of the monitor to turn off the setup
main menu.
If “AUTO SETUP COMPLETED” is not displayed, or the “AUTO SETUP FAILED”
message appears, repeat the auto setup procedure several times. If auto setup
continues to fail, complete the
Manual Setup
on page 28.
11. Press ENTER to exit the color-bar pattern. GXT150P Information is
displayed again.
12. Press ENTER. The entire screen is displayed in red. Press ENTER.
13. Press ENTER six times. Make sure the entire screen is displayed in the
following sequence:
Green
→
blue
→
white
→
black
→
8× 6 grid pattern
→
8× 10 grid
pattern.
14. When GXT150P Information is displayed, press ENTER.
15. When the IBM GXT150P Video Adapter menu is displayed, press ESC.
16. When the Test Completed message is displayed, press ENTER.
17. When Select Device to Test is displayed, press ESC to exit.
18. When the System Management Service panel is displayed, press F3.
19. Select Reboot.
20. Remove the diskette from drive A.
21. When “Do you want to restart the computer?” is displayed, select YES
and press ENTER.
You have completed the monitor setup.
If the screen flickers, repeat
the setup several times until
the flicker is minimised, or adjust
it manually by following Manual
Setup on page 28.
txteng.book Page 23 Friday, April 3, 1998 3:28 PM