Filter
Top Products
7
DEUTSCH
ENGLISHFRANÇAISESPAÑOLITALIANOJAPANESECOMPL & WARR
Auto Setup for the PC
Before carrying out
this section, it is very
important that The Setup
Diskette for Windows 95 or
Windows 98 has been run.
(see page 6)
Locate the operating system installed on your PC in the table below and
follow the appropriate instructions. You may choose to run
A
UTO
S
ETUP
for
each operating system that you use. This means that if you sometimes use
your monitor while running any version of Windows and sometimes also use it
from within DOS (not a DOS window), you must run
A
UTO
S
ETUP
for both
Windows and DOS. You may run versions of
A
UTO
S
ETUP
in any order.
If your PC does not run
with the setup diskettes
shipped with the monitor, refer
to
Manual Setup
on page 13
Before you begin
A
UTO
S
ETUP
for your PC:
1. Make a backup copy of the setup diskettes supplied with the monitor.
2. Make sure the PC’s video mode is set in the range of the supported
screen resolution shown in the table on page 20.
The
A
UTO
SETUP
process
only applies to the current
screen mode. When a new
mode is selected, repeat this
section to reset the monitor
You should perform
A
UTO
S
ETUP
for each screen mode you use.
Operating System Corresponding Auto Setup procedure
DOS
Auto Setup for DOS
on page 8
Windows 3.1
Auto Setup for Windows 3.1, Windows 95,
Windows 98 or Windows NT
on page 9
Windows 95
Windows 98
Window NT
Operating System/2 (OS/2)
Auto Setup OS/2
on page 11