Filter
Top Products
13
DEUTSCH
ENGLISHFRANÇAISESPAÑOLITALIANOJAPANESECOMPL & WARR
Manual Setup
Normally, you can complete the setup procedure using
A
UTO
S
ETUP
, however,
if your screen image is still distorted after you perform
A
UTO
S
ETUP
or the setup
diskette does not run on your system, perform
M
ANUAL
S
ETUP
.
If the monitor is in standby
mode (STANDBY ON), it
might automatically turn off
while you are waiting for it to
warm up.
To disable the Windows energy
saving feature by clicking on the
S
TART
button and selecting
S
ETTINGS
, C
ONTROL
P
ANEL
,
D
ISPLAY
, S
CREEN
S
AVER
. Make
sure that the E
NERGY
SAVING
FEATURES
OF
MONITOR
check
boxes are either empty, or that
the features are set to at least 20
minutes.
Your system may also have its
Power Saving utility enabled
through the Bios Setup Utility.
Refer to your system manual for
directions on disabling that bios
option.
1. Have your computer and monitor turned on for at least 15 minutes until
the monitor and video adapter have warmed up.
2. You may wish to start the program you most often use so that you can
adjust for a “typical” screen.
3. Press the OSD Enter button at the bottom of the monitor to display
the initial OSD menu.
4. Use an Arrow button (
-
or
+
) to select the IMAGE LOCK icon and
press the OSD Enter button to access the function.
5. Using an Arrow button (
-
or
+
), select
MANUAL
, press and then
press once to select
COARSE
. Left and right arrow adjustment
indicators become illuminated (see page 17
).
6. Use the Arrow buttons to correct (as much as possible) for noise in the
video signal then press to save the changes.
7. Use an Arrow button to select
FINE
and press the button.
8. Use the Arrow buttons again to tune the image to your liking.
9. When finished, press the Exit button four times to exit from the OSD.
You have completed the monitor setup.