Filter
Top Products
The procedures for running the diagnostics depend on the state of the diagnostics
run time options. See “Display or Change Diagnostic Run Time Options” on
page 9-15.
Run Error Log Analysis
The Run Error Log Analysis task invokes the Resource Selection List menu. When
the commit key is pressed, Error Log Analysis is run on all selected resources.
Run Exercisers
Note: The Run Exercisers task is only supported in Online Maintenance Mode on
CHRP systems.
This task provides a tool to troubleshoot intermittent system problems on AIX
Release 4.3.2 or later. This task provides an exerciser supervisor that controls the
selected exercisers.
When you select Run Exercisers from the Task Selection menu, the EXERCISER
SELECTION menu displays. Select the exerciser you want to run from this menu.
Each exerciser has other menus to set options for the exerciser.
Exerciser Commands (CMD)
Use the following commands as needed in the exerciser menus and reports. Not all
commands are available in each menu or report.
CMD Description
a Acknowledge an error.
b Back one page.
c Toggle between cycle count and last error.
e View the AIX error log.
f Page forward one page.
q Return to Main Menu.
r Refresh screen.
s Enable or disable beep on error.
x Exit system exerciser.
Acronyms
The following list describes acronyms used in the exerciser reports.
To toggle between two states (example Activate/Halt Devices), use the number of
the device.
Chapter 9. Introducing Tasks and Service Aids 9-27