Filter
Top Products
FrançaisDeutschEspañolPortuguese EnglishItaliano
Compliances
Federal Communications
Commision
(FCC) Statement
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to radio
or television receptions, which can be determined by
turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following
measures:
!
Reorient or relocate the receiving antenna.
!
Increase the separation between the equipment and
receiver.
!
Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
!
Consult the dealer or an experienced radio/TV
technician for help.
Properly shielded and grounded cables and connectors
must be used in order to meet FCC emission limits. Proper
cables and connectors are available from IBM authorized
dealers. IBM is not responsible for any radio or television
interference caused by using other than recommended
cables and connectors or by unauthorized changes or
modifications to this equipment. Unauthorized changes or
modifications could void the user's authority to operate the
equipment.
Power Cords
For your safety, IBM provides a power cord with a
grounded attachment plug to use with this IBM product.
To avoid electrical shock, always use the power cord
and plug with a properly grounded power outlet.
IBM power cords used in the United States and Canada
are listed by the Underwriters Laboratories (UL) and
certified by the Canadian Standards Association (CSA).
For units intended to be operated at 115 volts: Use a UL
listed and
CSA-certified cord set consisting of a minimum 18 AWG,
type SVT or SJT, three conductor cord, a maximum of
4.5 m (15 ft) in length and a parallel blade, grounding
type attachment plug rated 15 amperes, 125 volts.
For units intended to be operated at 230 volts (U.S.
use): Use a UL-listed and CSA-certified cord set
consisting of a minimum 18 AWG, type SVT or SJT,
three conductor cord, a maximum of 4.5 m (15 ft) in
length and a tandem blade, grounding type attachment
plug rated 15 amperes, 250 volts.
For units intended to be operated at 230 volts (outside
the U.S.): Use a cord set with a grounding type
attachment plug rated 13 amperes (minimum), 250 volts.
Use a cord set with a grounding type attachment plug.
The cord set should have the appropriate safety
approvals for the country in which the equipment will be
installed.
IBM power cords for a specific country or region are usually
available only in that country or region.
IBM Fig. #
(Plug Stnd.)
IBM P/N
(1.8M)
Using Countries or
Regions
4
(NEMA 5-15P)
125V
6952301
US, Canada, Mexico,
Brazil, Costa Rica, Peru,
Colombia, Ecuador,
Venezuela, Bolivia,
Panama, El Salvador,
Honduras, Nicaragua,
Dominican Republic,
Guatemala, Taiwan, Saudi
Arabia, Thailand,
Phillipines, Japan
5
(NEMA 6-15P)
250V
1838576
US, Canada, Mexico,
Brazil, Costa Rica, Peru,
Colombia, Ecuador,
Venezuela, Bolivia,
Panama, El Salvador,
Honduras, Nicaragua,
Dominican Republic,
Guatemala, Taiwan, Saudi
Arabia, Thailand,
Phillipines, Japan
6
(AS/NZS C112)
13F9939 Australia, New Zealand
TestedTo Comply
W ith FCC Standar
d
FOR HOME OR OFFICE USE
Kerr74_54_compliance.fm Page 0 Wednesday, September 5, 2001 6:16 PM