Filter
Top Products
found. The Add New Hardware Wizard window might open. Use
the wizard to install the correct device driver (the computer
considers the projector a Plug and Play monitor).
3. Turn on the lamp by pressing the lamp on/off button on the keypad. The
startup window opens.
4. If you connected a video player, turn it on. The video image displays on
the projection screen. If a computer source is active, press the source button
on the keypad or the video button on the remote control to display your
video image. You can select a default source to determine which source the
projector examines first during power-up for active video; see “Default
source” on page 1-22. Use the volume buttons to adjust the volume.
5. Turn on your computer.
Note: With some computers, the order in which you turn on the equipment
is very important. Most computers should be turned on last, after all
other peripheral devices have been turned on. See your computer
documentation to determine the correct order.
v The computer image displays on the projection screen. If a video source
is active, press the source button on the keypad or the computer button
on the remote control to display the computer image. Make sure that
your notebook computer’s external video port is activated; see “Portable
and mobile computer activation chart” in Appendix B for details.
v If necessary, make adjustments to the image using the on-screen menus
of the projector. To open the menus, press the menu button on the
keypad or remote control, then select the Display or Image submenu. For
information about the menus, see “Using the on-screen menus” on
page 1-15.
Turning off the projector
If you want to turn off the projector for a short period of time, press the
standby button on the keypad or remote control. This removes the image from
the screen for 15 minutes, but keeps the projector running. (You can change the
amount of time the projector stays in standby mode; see “Standby time” on
page 1-22 for details.) After 15 minutes, the lamp turns off and the projector
keeps running. To exit from standby mode, press the standby button again. It
might take several seconds for the projection lamp to reach full power and
project the image again.
Note: Lamp life will be extended if you turn the lamp off and then wait one
minute while the lamp cools before you unplug the projector. The Lamp
LED will light green when the lamp has cooled.
1-10 iLV200/iLC200 IBM Data/Video Projector: User’s Guide