Filter
Top Products
- 29 -
EPP Version
This option specifies the Enhanced Parallel Port specification version number that is used in the system. This option only
appears if the Parallel Port Mode option is set to EPP. The settings are 1.7 or 1.9.
Parallel Port IRQ
This option specifies the IRQ used by the parallel port. The settings are Auto, (IRQ) 5, or (IRQ) 7.
Parallel Port DMA Channel
This option is only available if the setting for the Parallel Port Mode option is ECP. This option sets the DMA channel used
by the parallel port. The settings are DMA Channel0, 1, or 3.
Serial Port IRQ
This option specifies the IRQ used by the serial port. The settings are Auto, (IRQ) 5, or (IRQ) 7
Onboard AC' 97 Audio
This function is to disable or enable AC’97 Audio. Choices: Auto; Disabled
Onboard Legacy Audio
This function allows configuring the Audio Codec to support legacy Sound Blaster mode. Choices: Auto; Disabled
Sound Blaster
This option is to Enable / Disable the onboard Audio support Sound Blaster decoding.
SB I/O Base Address
To configure the Sound Blaster decoding I/O range.
Choice: 220h – 280h
SB IRQ Select
To configure Sound Blaster IRQ channel.
Choice: 5,7 and 10
SB DMA Select
To configure Sound Blaster DMA channel.
Choice: 0,1,2 and 3
MPU-401
This option is to Enable / Disable onboard MIDI port decoding.
MIPU-401 I/O Address
If the onboard MPU-401 port is “Enabled”, it allows to set at 300h/310h/320h or 330h.
FM Port (388h-38Bh)
Allows you to Enable / Disable onboard FM Port synthesis for legacy compatibility
MPU-401