Filter
Top Products
- 6 -
11. Cautions
1. Application : This specification is applied to 6wire Touch Panel.
2. Warranty : TOUCH PANEL products manufactured to this specification shall be capable of meeting all
characteristics for a minimum period of 12 months the date of shipping from NAGASAKI IPC when stored or used as
specified under normal conditions within the contents of these sheets. If TOUCH PANEL products are not stored or
used as specified herein, it will be void the 12 months warranty.
3. Features
Type Analog Resistive Type Touch Panel
Input Mode Polyester Pen or Finger
Structure Film----- ITO Film Glass----ITO Glass
4. Characteristics
4.1 Operating Temperature Range : From –20 to 60 (Humidity 90%RH or lower, no dew condition shall be
acceptable)
4.2 Storage Temperature Range : From –30 to 70
(Humidity 90%RH or lower, no dew condition shall be acceptable)
4.3 Input Method
(1) with Polyester Pen
Operation and measurement with a pen must be carried out under the following trip condition
Material Polyester Tip SR 0.8 millimeter
(2) with Finger
Operation and measurement with a finger must be carried out under the
Material Silicon rubber (Hardness: 60º Hs) Tip SR 12.5 millimeter
5. Electrical Specifications
5.1 Linearity Direction ± 1.5% or less (with calibration controller)
5.2 Insulation Resistance 20 MO or more @ DC 25V
5.3 Chattering Time 10 millisecond or less @ 100KO
6. Mechanical Specifications Item No. Item Ratings Test Methods & Condition
6-1 Operating Force with Polyester Pen SR 0.8
According to applicable product specification Less than 150g Using a load cell with a Polyester Pen conforming to the
specifications set forth in item 4.3 (1) attached to its tip, apply a vertical load within the valid area.
Using themeasurement circuit illustrated in diagram 6-1 below, take the gauge value when the voltage value 4.5V or
greater as the pressure load value.
6-2 Surface Hardness : 2H or Higher JIS-K5400