Filter
Top Products
Step 5. Stopping the Diagnostics
1. If you are running Online diagnostics, shut down the system using the following
procedure:
a. Press F3 repeatedly until you get to the Diagnostic Operating Instructions, then
follow the displayed instructions.
b. Press F3 once, and then follow the displayed instructions to shut down the
system.
2. If you changed any attributes on your ASCII terminal to run the diagnostics, change
the settings back to normal.
3. This completes the system verification. Report the SRN, if you received one, to the
service organization. To do a normal boot, turn off the system unit and wait 30
seconds, and then set the power switch of the system unit to On.
Chapter 7. Using the System Verification Procedure 147