IBM Partner Pavilion 6792 Personal Computer User Manual


 
See the following illustration for the location of parts on the system board.
1 Microprocessor 9 Battery
2 DIMM connectors (1, 2, 3 left to right) 10SCSI LED connector
3 Front panel connector 11PCI slots
4 Power connector 12Front panel audio connector
5 Diskette drive connector 13CD-ROM audio connector
6 Primary IDE connector 14AGP slot
7 Secondary IDE connector 1512V Power connector
8 Clear CMOS/Recovery jumper
Installing memory
Your computer has three connectors for installing dual in-line memory modules
(DIMMs) that provide up to a maximum of 1.5 GB of system memory.
Installing DIMMs
When installing DIMMs, the following rules apply:
v Fill each system memory connector sequentially, starting at DIMM 1
v Use 3.3 V, synchronous, 168-pin, unbuffered, 133 MHz nonparity synchronous
dynamic random access memory (SDRAM)
v Use 64 MB, 128 MB, 256 MB, or 512 MB DIMMs in any combination
v DIMM heights of 38.1 mm (1.5 inches)
To install a DIMM:
1. Remove the cover. See Removing the cover on page 29.
2. You might have to remove an adapter to gain access to the DIMM slots. See
Installing adapters on page 32.
Chapter 4. Installing internal options desktop model 31