Filter
Top Products
5-10 sec.
source
Turn on projector and source
1
Connect the power cord to the
projector and to an electrical
outlet
The power light on the projector will light amber.
2
Slide open the lens cover
3
Turn on the projector
Touch the power light (or press power on the remote).
The power light will start blinking green.
4
Wait for the lamp to warm up
After a few seconds, the power light will stop blinking
and turn green. It can take a minute for the lamp to
reach full brightness.
!
Warning: Do not look directly into the lens while
the projector is being used.
5
Turn on computer or other source
You may need to press a specic key combination to activate
your laptop’s external video port. On most laptops, hold
down the FN key while pressing a key labeled CRT/LCD, LCD/
VGA, a monitor icon , or similar. Key combos for popular
models:
Apple F7 HP/Compaq Fn+F4 or Fn+F6 Sony Fn+F7
Dell Fn+F8 IBM ThinkPad Fn+F7 Toshiba Fn+F5
Fujitsu Fn+F10
Complete laptop activation chart at www.infocus.com/support
i
Important: If there is still no video, restart your
computer (rst make sure it’s connected to the
projector and the projector is turned on).
6
Change source if needed
If needed, press source (on the projector or remote)
to view the source. You may have to press it more than
once.
4