Filter
Top Products
(
TROUBLESHOOTING
)
If there is no picture or the picture is blank
If “Signal out of range” is shown, or the picture looks bad
If the replace lamp light is on
If the high temperature light is on
If the service required light is on
If the power light is o, make sure the power cord is connected and plugged into a live
electrical outlet. If the power light is amber and not blinking, touch the power light (or
press power on the remote).
Check video source and cables. Make sure the video source (computer, DVD player, VCR,
etc.) is turned on and cables are securely connected between the source and the projector.
If your computer is connected using DisplayLink (not VGA), please see the DisplayLink
Manager User’s Guide for more troubleshooting information.
Make sure your computer’s video port is enabled. Press the key combination that activates
your laptop’s external video port (see step
4
). If there is still no image, restart your laptop.
Press the Source button. You may need to press it several times to view the correct
source.
Press the Auto Image button.
Press the Auto Image button. If that doesn’t help (and the source is a computer), reduce
your computer’s display resolution or vertical refresh rate.
Turn the projector o and wait at least one minute, then turn it on again. If the replace
lamp light turns on again, the lamp needs to be replaced. For lamp replacement
instructions, see the Reference Guide, which can be downloaded at
www.infocus.com/support
Only InFocus genuine lamps are tested for use in this projector.
Turn the projector o and remove anything that may be blocking the air vents on
its side. Leave the projector o for at least one minute to let it cool before turning it on
again. Important: Continuous operation at high temperature may reduce the lifetime of
the lamp and/or projector.
Turn the projector o and wait at least one minute, then turn it on again. If the
service required light turns on again, the projector needs to be serviced. See below for
service contact information.
More troubleshooting options are in the Reference Guide
Download it at www.infocus.com/support
Warning: In the unlikely event of a lamp rupture, particles may be ejected from the
projector. Keep out of the area under and around the projector while the projector is in
use. See the safety instructions booklet for more details.
auto image
auto image
source
!