Filter
Top Products
IN5316HD/IN5318 – User’s Manual
– 45 –
Problem: The image is flat with no contrast
Adjust the Contrast setting in the PICTURE >> Basic menu of the OSD.
Problem: The color of the projected image does not match the source image.
Adjust the Color Temperature and Gamma settings on the PICTURE >> Advanced menu of
the OSD.
Lamp Problems
Problem: There is no light from the projector
1. Check that the power cable is securely connected.
2. Ensu
re the power source is good by testing with another electrical device.
3. Re
start the projector in the correct order and check that the PWR LED is solid Green.
4. If you have repla
ced the lamp recently, try resetting the lamp connections.
5. Repl
ace the lamp module.
6. Put the old lamp ba
ck in the projector and have the projector serviced.
Problem: The lamp goes off
1. Power surges can cause the lamp to turn off. Unplug and re-plug the power cord and
press the Power button.
2. If the lamp still does not i
gnite, unplug the projector and allow it to cool for 60 minutes.
Replace the lamp.
3. If a new lam
p does not resolve the issue, put the old lamp back into the projector and ar-
range to have the projector repaired.
Remote Control Problems
Problem: The projector does not respond to the remote control
1. Direct the remote control towards remote sensor on the projector.
2. Ensu
re the path between remote and sensor is not obstructed.
3. Turn off any fluore
scent lights in the room.
4. Che
ck the battery polarity.
5. Repl
ace the batteries.
6. Turn off othe
r infrared-enabled devices in the vicinity.
7. Repl
ace the remote control.