Filter
Top Products
21
Connecting an External Speaker
To connect one or two external speakers, plug the speaker cable
into the (audio out) connector on the projector.
NOTE: The external speakers
must be amplified.
F
IGURE 20
Connecting an external speaker
Powering up the Projector and Adjusting the Image
NOTE: Always use the power cord
that shipped with the projector.
1
Remove the lens cap.
2
Plug the power cord into the front of the projector, then plug it
into your electrical outlet. A surge-protected power strip is
recommended if power surges are common in your area.
3
Turn on the projector by pressing the “I” side of the power
switch on the front of the projector.
CAUTION: If the lamp LED
remains solidly lit after the projec-
tor has powered on, the lamp
needs to be replaced. Refer to
“Replacing the Projection Lamp”
on page 41 for more information.
•
The In Focus startup screen displays and the Power LED
lights (Figure 25 on page 27).
4
If you connected a video player, turn it on.
•
Press the
video
button on the keypad to display the image
from your video player. (You can select a default source to
determine which source the projector examines first during
power-up for active video; see “Default Source” on
page 38.)
•
Use the
volume
buttons to adjust the volume.