Filter
Top Products
32
initio
®
2 If you are installing Windows NT from a CD version, locate the Windows NT
Setup Disk for CD-ROM Installation. Make a backup copy of this diskette before
installation.
3 Insert the backup Windows NT Setup disk into drive A: and turn on your com-
puter.
4 Follow the instructions on the screen until you come to a window titled:
WINDOWS NT WORKSTATION SETUP (for servers, it will read WINDOWS NT SERVER
SETUP
).
Press ENTER to continue setting up Windows NT.
Select S to skip mass storage detection.
Select S to configure additional SCSI adapters.
5 When prompted by the Windows NT installation, scroll down the list and select
OTHER (Requires disk provided by a hardware manufacturer) from the
list of Additional SCSI Adapters. A message will appear on screen stating to:
Remove diskette in drive A and set it aside.
Insert INI-9XXXU/9XXXUW DRIVER DISK 1 and press <ENTER>.
Select: Initio INI-9XXX SCSI Host Adapter and press <ENTER>.
6 The Initio host adapter driver is now installed The on-screen instructions will
continue for a complete installation of Windows NT. Refer to your Windows NT
users manual for completion of the operating system installation procedure.
Adding or updating the Initio driver to an existing Win-
dows NT system:
For computer systems using other SCSI host adapters or an IDE drive to provide the
system boot routine, these instructions will guide you through the INI-9XXX host
adapter driver installation. The Windows NT driver will be found on the INI-9XXXU/
9XXXUW DRIVER DISK 1
. It is important that the SCSI bus hardware and Windows NT
are installed and configured before proceeding further.
1 Once a Windows NT session is established, use your installed mouse or the appropri-
ate key strokes to select MY COMPUTER from the Main Desktop. Execute the
following steps:
Select CONTROL PANEL from within the MY COMPUTER group.
Select SCSI ADAPTERS from within the CONTROL PANEL group.
2 Select the DRIVERS tab from within the SCSI ADAPTERS group.
In the DRIVERS window, select ADD
Microsoft Windows NT Driver Installation