Filter
Top Products
36
initio
®
6 Select installation type. <ENTER>
7 Enter server name when prompted <ENTER>
At this point the boot files will be copied to the hard drive.
8 After the files are finished being copied you may encounter the following message:
Install found the following hardware but found
More than one driver supporting this hardware
PCI.XXXX.XXXX.XXXX.XXXX.XX
Press <Enter> for a list of drivers to choose
From or <F3> to continue without selecting
Press <F3> to continue. Repeat if this screen is shown again.
9 A screen listing the drivers will be displayed. INI9100 will be listed as the selected
driver. This completes loading the Host Adapter Driver, Follow the on-screen direc-
tions to complete the Novell NetWare installation.
This will load the HAM driver. If a DSK driver is required or an updated HAM driver is
needed it is recommended that you complete the installation and use NetWares
INSTALL utility to update/change the driver.
Adding the Initio driver to an existing IntraNetWare sys-
tem
1 To begin the installation you will need to change the directory to the location of the
server and initialize the network server, e.g.,
Type CD \ NWSERVER <ENTER>
Type SERVER <ENTER>
2 At the NetWare prompt, Type LOAD INSTALL <ENTER>.
3 Select Driver Options from the window by highlighting it using the UP or DOWN
ARROW keys, press <ENTER>
Select Configure disk and storage device drivers from the window by high
lighting it using the UP or DOWN ARROW keys, press <ENTER>
4 Highlight Discover and load additional drivers and press <ENTER>
5 NetWare will load INI9100.HAM modify the STRATUP.NCF file to reflect the new
changes.
Novell NetWare Driver Installation