Filter
Top Products
2
16
Hardware Installation
2.6 Jumper Settings for Wake-On-Keyboard/
Wake-On-Mouse
Jumper JP1
Wake-On-Keyboard/Wake-On-Mouse
The system board supports the Wake-
On-Keyboard/Wake-On-Mouse function.
This function allows you to use the
keyboard or mouse to power-on the
system. By default, JP1 is disabled. To use
this function, set JP1 to 2-3 On.
Keyboard/Mouse Power On in the
Integrated Peripherals setup of the
Award BIOS must be set accordingly.
Refer to chapter 3 for details.
Warning:
1. If JP1 was previously enabled
with a password set in the
KB Power On Password field, and now you wish to disable
the Wake-On-Keyboard (password) function, make sure to
set the Keyboard/Mouse Power On field to Disabled prior
to setting JP1 to disabled. You will not be able to boot up
the system if you fail to do so.
2. The power button will not function once a keyboard
password has been set in the KB Power On Password
field of the Integrated Peripherals setup. You must type the
correct password to power-on the system.
3. The 5VSB power source of your power supply must
support
≥
720mA (minimum).
2-3 On: Enable1-2 On: Disable
(default)
123 123