Filter
Top Products
43
3
Award BIOS Setup Utility
Assign IRQ for VGA
When Enabled, the system automatically assigns an IRQ for the VGA
card installed. Your VGA card will need an IRQ only when using the
video capture function of the card. If you are not using this function
and a new device requires an IRQ, you can set this function to
Disabled. The IRQ (previously occupied by the VGA card) will be
available for your new device.
Note:
When Disabled, a Yellow mark will appear in Windows
95s
Device Manager.
Assign IRQ for USB
When Enabled, the system automatically assigns an IRQ for the USB
device connected to your system. However, if you are not using USB
devices and an ISA slot requires an IRQ, set this function to Disabled.
The IRQ previously occupied by the USB device will be available for
the ISA slot.
Note:
When Disabled, a Yellow mark will appear in Windows
95s
Device Manager.
PCI Slot 1 Use IRQ to PCI Slot 4 Use IRQ
By default, an IRQ is automatically assigned to each PCI slot. You may
also manually assign an IRQ to these slots. The options are: 3, 4, 5, 7,
9, 10, 11, 12, 14 and 15.
3.1.6 Load Fail-Safe Settings
The Load Fail-Safe Settings option loads the troubleshooting default
values permanently stored in the ROM chips. These settings are not
optimal and turn off all high performance features. You should use these
values only if you have hardware problems. Highlight this option on the
main menu and press <Enter>. The message below will appear.
Load Fail-Safe Settings (Y/N)? N
If you want to proceed, type <Y> and press <Enter>. The default
settings will be loaded.