Intel Intel Core Duo/Solo 945GM Computer Hardware User Manual


 
ADE-6050 Users Manual
38 / 48
4.2.4.2.4. IDE Primary/Secondary Master/Slave PIO
The four IDE PIO (Programmed Input/Output) fields let you set a PIO mode (0-4) for each
of the four IDE devices that the onboard IDE interface supports. Modes 0 through 4
provide successively increased performance. In Auto mode, the system automatically
determines the best mode for each device.
The choice: Auto, Mode 0, Mode 1, Mode 2, Mode 3 and Mode 4.
4.2.4.2.5. IDE Primary/Secondary Master/Slave UDMA
Ultra DMA/33 implementation is possible only if your IDE hard drive supports it and the
operating environment includes a DMA driver (Windows 95 OSR2 or a third-party IDE bus
master driver). If your hard drive and your system software both support Ultra DMA/33,
select “Auto” to enable BIOS support.
The choice: Auto, Disabled.
4.2.4.2.6. On-Chip Serial ATA
There are five Serial ATA fields let you set the Serial ATA.
The choice: Disabled---Disabled SATA Controller.
Auto---Auto arrange by BIOS.
SATA Only---SATA is operating in legacy mode.
Combined Mode---PATA and SATA are combined. Max. of 2 IDE drives in
each channel.
Enhanced Mode---Enable both SATA and PATA. Max. of
4 IDE drives are supported.
4.2.4.2.7. SATA Ports Speed Settings
This item allows you set the SATA Ports Speed.
The choice: Disabled, Force GEN I, Force GEN II.
4.2.4.2.8. PATA IDE Mode
This function allows to select PATA IDE mode.