Filter
Top Products
Onboard FDC Controller
Select Enabled if your system has a floppy disk controller (FDC)
installed on the system board and you wish to use it. If you install
an add-in FDC or the system has no floppy drive, select Disabled in
this field.
UART Mode Select
Select an operating mode for the second serial port:
Normal RS-232C serial port
Standard RS-232C serial port
IrDA 1.0 Infrared port compliant with IrDA 1.0
specification
IrDA SIR IrDA-compliant serial infrared port
IrDA MIR 1 MB/sec infrared port
IrDA FIR Fast infrared standard
FIR Fast infrared standard
MIR 0.57M 0.57-MB/sec infrared port
MIR 1.15M 1.15-MB/sec infrared port
Sharp IR 4-MB/sec data transmission
HPSIR IrDA-compliant serial infrared prot
ASK IR Amplitude shift keyed infrared port
UART2 Duplex Mode
In an infrated port mode, this field appears. Full-duplex mode
permits simultaneous two-direction transmission. Half-duplex
mode permits transmission in one direction only at a time. Select
the value required by the IR device connected to the IR port.
Hot Key Power On
Simply pressing on the preselected keyboard key the system will
power on.