Click the check box to enable, then click
“Apply” to further congure the function (all within the Direct Link panel).
Specify the MAC address of the client adapter you
want to direct link to and click “Apply” to add to the DLS Status
table (below).
Specify the timeout value for the direct link being
set up.
On this screen, you can click the hyperlink for information on the wireless
chipset manufacturer. Basic information about the utility (driver, EEPROM
version, etc.) also displays, as do various addresses for quick reference.
NOTE: This adapter features Turbo Mode, which delivers a higher
throughput than IEEE 802.11g standard (up to 54 Mbps) by compressing
data and decreasing the wait time for sending data to routers or access
points. Turbo Mode is enabled automatically without any conguration.
The adapter supports WPS (Wi-Fi Protected Setup), allowing connection
to wireless APs without complicated procedures. Two WPS conguration
methods are available: PBC (push-button conguration) and PIN.
Wireless access points offering WPS service are shown
22
CONFIGURATION