Intermec PF8D Printer User Manual


 
Chapter 2 — Installing the Printer
PF8d/PF8t Printers User’s Guide 17
5 Insert the compact flash card in the compact flash adapter.
Make sure that the card is oriented correctly to fit in the slot.
Push firmly to seat the card.
6 Install the compact flash card slot cover.
7 Close the top cover and turn on the printer power.
Understanding Auto-Sensing Mode
The Auto-Sensing mode can be used for the following:
Adjusting the label gap sensor
Printing a test label with a test pattern and list of the printer’s
current settings
•Entering Dump mode
To use Auto-Sensing mode
1 Load media in the printer.
2 Press and hold the Feed button while turning the Power
switch to the On position (
).
The status LED blinks green for 2 seconds, blinks red for 2
seconds, and then blinks green again.
Compact ash
card slot cover
Note: If you are using continuous stock or gap media, release
the Feed button when the status LED is blinking green. If you
are using black marked media, release the Feed button when
the LED is blinking red.