Filter
Top Products
70 EasyCoder PX4i User’s Guide (IPL version)
Chapter 8 — Options
The cutting edge will rotate when the power is switched on
and when the printer is re-booted. Always keep the cutter
in closed position during operation. Switch off the power
or disconnect the cutter before cleaning. Keep your fi ngers
away from cutting parts!
Note: The cutter must be enabled in the Confi guration part of
the Setup Mode, see Chapters 6 and 7.
Fan-Fold Guides
The fan fold guides provide a more exact guiding of the media, when the
supply is placed outside the media compartment, for example a stack of
fan-folded tickets. The guides come as an operator-installable kit with
installation instructions. The guides can be fi tted in the upper or lower
slot in the rear plate.
Instructions for loading the media is included in the section “External
Supply” in Chapter 4, “Media Load.”
Media Roll Retainer
The media roll retainer is intended for applications where the media may
become misaligned on the media supply hub. The plastic wing-shaped
retainer is simply pressed onto the media supply hub outside the media
roll. Operator-installed, no tools are required.
3-inch Adapter
The 3-inch/76 mm adapter is included in the package and makes it
possible to use media rolls with 3 inch/76 mm inner diameter cardboard
cores.
The adapter is pressed onto the media supply hub and is held in place
by a screw. When fi tting the adapters, make sure that the screw hits a
rounded plastic surface, not a metal leaf spring. Illustrations of how to
load the media using the adapter can be found in Chapter 4.