Filter
Top Products
16 iRobot Dirt Dog Owner’s Manual
Sending Schedules
After setting a cleaning time, you need to send the schedule to Dirt Dog and
the scheduling Virtual Walls.
To send a schedule to your Dirt Dog:
1
Power on Dirt Dog with the Power button.
2
Open the Scheduler Remote Control’s front cover,
point the remote at Dirt Dog and press Send All. The
display will flash to indicate the remote is sending
the schedule. Dirt Dog will play a song to indicate
the schedule is received and the Status light will
begin blinking.
3
Make sure Dirt Dog is on the Home Base or in the
center of the area you want to clean. Dirt Dog will
clean at the time you have scheduled.
Dirt Dog’s Status light will blink amber to indicate
that Dirt Dog is scheduled to clean.
To accept a schedule, Dirt Dog must either be at least eight feet from the
Home Base or charging on the Home Base and Dirt Dog’s power must be on.
iRobot Scheduler, Virtual Walls, and Home Base all operate using invisible
infrared beams. If used in the same area, Dirt Dog may see multiple infrared
signals and not respond to commands. Make sure all Virtual Walls are
turned off when using Scheduler.