Filter
Top Products
You can update the firmware on your Jabra A335w to benefit from the latest
editions. Before you can update the firmware, you need to install the Jabra
PC Suite. See chapter 8 on how to do this. You update by downloading a new
firmware file in the following way:
Insert the Jabra A335w dongle
To update your dongle, you must insert it into your computer.
WARNING: Do not remove the dongle while the firmware is being updated.
WARNING: Make sure your computer will not shut down, or enter sleep or standby
mode, while the firmware is being updated.
Download the firmware file
To download the firmware file, go to www.jabra.com/A335w and save the
firmware file on your computer.
Run the Jabra Device Firmware Updater wizard
To run the updater wizard, go to Start on your computer to launch the Jabra
Device Firmware Updater wizard:
• when asked to select which device to update, select the Jabra A335w.
• when asked to find the firmware file, locate it where you have just saved it on
your computer, and select it.
During the installation
• You may get a notice that your dongle is already equipped with the latest
edition of the firmware. In that case, cancel the update.
• Your computer runs the Found New Hardware wizard. If you use Windows
Vista, the wizard will run automatically. If you use Windows XP, please,
complete the wizard. You may get a Windows Security message. Please, ignore
the message and continue.
When the update is complete, press Finish – the latest edition of the firmware is
now installed on your dongle.
If the firmware is not successfully installed, a failure message will be shown - just
repeat the Jabra Device Firmware Updater procedure as described above.
8
English
How to update firmware
9