Filter
Top Products
The following abbreviations are used to represent values for Control Module Pin-Out data
I Input PG Power Ground CAN CAN Network D Serial and Encoded Data
O Output SS Sensor / Signal Supply V SCP SCP Network V Voltage (DC)
B+ Battery Voltage SG Sensor / Signal Ground D2 D2B Network PWM Pulse Width Modulated
CAUTION: The information on this data page is furnished to aid the user in understanding circuit operation. THIS INFORMATION SHOULD BE USED FOR
REFERENCE ONLY.
NOTE: The characteristics listed are approximately those that can be expected at the control module connector pins with all circuit connections made and all
components connected and fitted.
Refer to the front of this book for detailed information and illustrations regarding the location and identification of harnesses, relays, fuses, grounds, control
modules and control module pins.
DATE OF ISSUE: December 2001
Fig. 14.3
COMPONENTS
Component Connector(s) Connector Description Location
GENERAL ELECTRONIC CONTROL MODULE CA86 23-WAY / GREY BEHIND INSTRUMENT PANEL RH SIDE
CA87 23-WAY / GREEN
IP5 23-WAY / BROWN
IP6 23-WAY / WHITE
JB172 23-WAY / BLUE
DOOR LATCH ASSEMBLY – LH FRONT FL3 8-WAY / BLACK LH FRONT DOOR
FL9 2-WAY / BLACK
DOOR LATCH ASSEMBLY – RH FRONT FR3 8-WAY / BLACK RH FRONT DOOR
FR9 2-WAY / BLACK
ROOF CONSOLE RC22 22-WAY / BLACK ROOF, CENTER FRONT
RC30 4-WAY / BLACK
RC31 2-WAY / BLACK
RC33 4-WAY / BLACK
RC34 6-WAY / BLACK
SLIDING ROOF CONTROL MODULE RC14 10-WAY / GREY ROOF CONSOLE
HARNESS IN-LINE CONNECTORS
Connector Connector Description Location
CA15 20-WAY / BLACK / DOOR HARNESS TO CABIN HARNESS DRIVER SIDE A POST
CA16 20-WAY / BLACK / DOOR HARNESS TO CABIN HARNESS DRIVER SIDE A POST
CA20 20-WAY / BLACK / DOOR HARNESS TO CABIN HARNESS DRIVER SIDE A POST
CA21 20-WAY / BLACK / DOOR HARNESS TO CABIN HARNESS DRIVER SIDE A POST
CA36 16-WAY / GREEN / CABIN HARNESS TO ROOF HARNESS LH LOWER A POST
GROUNDS
Ground Location
G4 PASSENGER COMPARTMENT / RH LOWER A POST
G5 PASSENGER COMPARTMENT / RH LOWER A POST
G15 PASSENGER COMPARTMENT / LH LOWER A POST
FOR CONTROL MODULE PIN-OUT INFORMATION, UNFOLD PAGE TO LEFT.
CONTROL MODULE PIN-OUT INFORMATION
Control Module
Pin Description and Characteristic
I CA86-16 SET SWITCH: OPEN CIRCUIT / GROUND
O CA87-17 GLOBAL CLOSE REQUEST: 20 ms PULSED SIGNAL
O CA87-20 VEHICLE SPEED SIGNAL: PULSED SIGNAL, 8000 PULSES PER MPH
I IP5-3 EXTERNAL ANTENNA
S IP5-18 SCP –
S IP5-19 SCP +
SG IP6-1 LOGIC GROUND: GROUND
B+ JB172-1 BATTERY POWER SUPPLY (LOCKING): B+
NOTE: Refer to the Appendix at the rear of this book for Network Messages.