Filter
Top Products
x
DATE OF ISSUE: December 2001
Jaguar X-TYPE 2.0L/2.5L/3.0L
Appendix
CAN Message Matrix
1F5h
CAN FUEL LEVEL RAW 1 Fuel level sender 1 signal (before signal conditioning)
IC X
1F5h
CAN FUEL LEVEL RAW 2 Fuel level sender 2 signal (before signal conditioning)
IC X
3E9h
CAN GEAR POSITION ACTUAL Transmission gear positions: N, 1, 2, 3, 4, 5, R, or shift in progress
TCM XXXX X
3E9h
CAN GEAR POSITION SELECTED
Transmission rotary switch positions: P, R N, D, 4, 3, 2, or selector
between positions signals
TCM X X X
3E9h
CAN TRANSMISSION SHIFT MAP
TCM shift map in use signal: Normal, Sport, Hot, Gradient, Traction,
Manual, or Cruise
TCM XXXX
3E9h
CAN TRANSMISSION OIL TEMPERATURE
Transmission fluid temperature –40 °C to 214 °C. Note: will not
exceed 150 °C
TCM X X
3E9h
CAN TRANSMISSION MALFUNCTION
Transmission malfunction data, also activate transmission warning
signals
TCM XXXX X
3E9h
CAN TCM CONFIG FLAG TCM PECUS programmed YES / NO
TCM X
3E9h
CAN TORQUE CONVERTER STATUS Torque converter clutch disengaged, engaged or constant slip
TCM XXXX
3E9h
CAN GEAR SELECTION FAULT CAN GEAR POSITION SELECTED signal validity
TCM X X X
3E9h
CAN IDLE NEUTRAL CONTROL Idle neutral control in / not in progress
TCM X
3E9h
CAN PERFORMANCE MODE INDICATION Switch Performance Mode LED ON / OFF
TCM X
3E9h
CAN TCM FAULT CODE MIL STATUS Indicates flagged DTC requires MIL illumination
TCM X
3E9h
CAN OBD II TCM CLEAR ACK Confirms transmission OBD DTCs cleared
TCM X
3E9h
CAN TRANSMISSION FAULT CODES Indicates transmission fault codes to store ECM
TCM XXXX
3E9h
CAN GEAR POSITION TARGET Next actual transmission gear position (for traction control)
TCM XXXX
41Ah
CAN PRESSURE TRANSDUCER A/C refrigerant pressure, for fan control and diagnostics
TCM X
41Ah
CAN ENGINE INTAKE TEMPERATURE Engine intake air temperature: -40 °C to 80 °C (-40 °F to 176 °F)
ECM X
41Ah
CAN A/C CLUTCH INHIBIT STATUS Confirms A/C compressor clutch ON / OFF
ECM X
41Ah
CAN ELECTRICAL LOAD MANAGEMENT
Inhibit: heated rear window, windshield, wiper park area, automatic
heated windshield.
ECM X
41Ah
CAN COOLING FAN FEEDBACK
Actual cooling fan speed. Response to COOLING FAN REQUEST
message
ECM X
441h
CAN AMBIENT TEMPERATURE Outside air temperature -40 °C to 80 °C (-40 °F to 176 °F)
A/CCM X X
441h
CAN COMPRESSOR TORQUE Predicted A/C compressor torque in 100 ms
A/CCM X
441h
CAN A/C COMMANDS
Request A/C compressor ON / OFF. Maximum heat required: YES / NO
A/CCM X
441h
CAN A/C STATUS
Indicates: windshield, rear door mirrors, and windshield wiper park
area heater ON / OFF and blower speed
A/CCM X
No.
Message Name Usage
Source
Receivers
ABSCM
ABS/TCCM
DSCCM
ECM
TCM
IC
A/CCM
HLCM
JGM
SWS
YRS
DIAG