Juniper Networks 208 Network Router User Manual


 
Juniper Networks NetScreen Release Notes
ScreenOS 5.0.0r9-FIPS P/N 093-1638-000, Rev. A Page 26 of 42
discrepancy, you had to read the text description of the trap type to identify
it. Now you can refer to the trap type value to identify it. For example, the
traditional SNMP trap type value for a Cold Start event is 0. Please check
the ScreenOS Messages Guide for the correct values in ScreenOS 5.0.0.
02062 – Under certain circumstances, Track-IP was not sent out and caused
the NSRP failover operation to fail.
02059 – When you changed an IKE gateway from Static IP to Dynamic IP
using the WebUI, the procedure automatically changed the setting from
Main Mode to Aggressive mode.
02057 – Multiple custom addresses or service groups in a policy sometimes
caused a Juniper Networks security appliance to fail during restart.
02050 – Configuring an address group from an Apple computer using
Internet Explorer sometimes caused a Juniper Networks security appliance
to fail.
02047 – When the device received a packet with Ethernet type 0x8888, the
device failed.
02045 – Under certain circumstances, the device incorrectly flagged and
dropped IP-Spoof packets.
02044 – An operation using SSH version 1 to access the device failed when
using Radius for administration authentication.
02035 – The device did not allow URL filtered traffic when the URL queue
was full and the URL queue size was too small to process heavy traffic.
02034 – In transparent mode, when selecting the WebAuth option in the
WebUI for the V1-Untrust Zone, it appeared to take effect, but when closing
the window and then returning to the V1-Untrust configuration window, the
WebAuth option was no longer selected.
02019 – You could not use the WebUI to remove the key id and preshared
key of the primary NTP server.
02018 – The Juniper Networks security appliance failed when applying
debug commands, for example, the set ffilter command.
02001 – If a dynamically added route and a static route on a device both used
the same interface default gateway as the next hop, when the dynamic
route’s interface default gateway changed, the static route’s gateway did not
change with it as expected.
01993 – You could not modify management services on interfaces configured
in the WebUI environment to obtain addresses using DHCP.
01986 – In an NSRP environment, the primary device sometimes had more
active XAuth users than the backup device because the garbage collection
mechanism for IPSec SA removed XAuth users from the backup device at a
more accelerated rate than it did from the primary device.