Juniper Networks 208 Network Router User Manual


 
Juniper Networks NetScreen Release Notes
ScreenOS 5.0.0r9-FIPS P/N 093-1638-000, Rev. A Page 28 of 42
36717 – When upgrading to ScreenOS 5.0.0, the maximum number of
address groups allowed for Layer2 predefined zones incorrectly got set to the
same number as for custom zones. As a result, if the number of address
groups in Layer2 predefined zones surpasses the maximum number allowed,
some address groups got removed during the upgrade.
32690 – (Juniper NetScreen-5GT only) When multiple devices were
connected with AV scanning enabled on policies, no traffic passed through
the devices. For example, if two devices were connected together and both
had AV scanning enabled on policies, no traffic traversed the devices.
02081 – The active user table failed to clear automatically. New users were
denied until the table was manually cleared.
02079 – In an instance where the system was running in transparent mode,
when you enabled traffic shaping mode, the system dropped all packets.
02038 – Reboots occurred occasionally when traffic matched policies which
had authentication enabled.
02027 – An SNMP sysObject OID reply returned in the wrong format.
02006 – Enabling DHCP Relay could cause a Juniper Networks security
appliance to crash.
01972 – A DHCP relay packet sometimes caused a Juniper Networks
security appliance to crash.
01971 – You were not able to add physical interfaces (different ports) of a
Juniper Networks security appliance in the same redundant interface group.
01968 – (Juniper NetScreen-5GT only) Ident-reset packets that terminated
on the device might have caused the device to restart.