Juniper Networks 5XT Network Router User Manual


 
Juniper Networks NetScreen Release Notes
ScreenOS 5.0.0r9-FIPS P/N 093-1638-000, Rev. A Page 12 of 42
02580 – When you created a new custom service, and then configured a VPN
using IKE, the Proxy ID setting in the VPN Autokey IKE configuration
incorrectly defaults to the new custom service, and not the ANY service.
02555 – The system incorrectly created sessions for embedded ICMP
packets.
02530 – A TCP stack error caused the BGP neighbor state to change to the
Idle state before the BGP holddown time value (default of 180 seconds)
expired. The BGP neighbor state, a setting determined by whether the
current BGP routing instance, can detect its neighbor to be active, and is not
supposed to render the neighbor Idle until no neighbor response occurs after
the holddown time elapses.
02519 – In an instance where an active-passive HA pair of Juniper
NetScreen-208, the SA (Security Association) went out of sync, the backup
device became corrupted and the device failed because memory on both
devices became corrupted.
02498 – The status link LED incorrectly indicated that the Fast Ethernet
port on both the Juniper NetScreen-500 and Juniper NetScreen-200 was
running at 10 Mbps while the physical link was correctly running at 100
Mbps.
02486 – In some instances, after enabling a WebSense server, when you
accessed the Microsoft Outlook Calendar utility, you would lose connectivity
to Outlook Email.
02482 – Slow http/https through vpn. Bug in H323 implementation can
possibly cause session leak R. HTTP cant pass if unset flow tcp seq + set flow
tcp syn combo is used.
02385 – When you selected multiple source address groups in an intra-zone
policy where the source was Trust and the destination was Trust, then the
groups were not displayed properly in the Policy list.
02152 – In instances where you created an intra-zone policy with the source
zone was Trust and the destination zone was untrust and that used multiple
addresses, the Policy list displayed the same entity for both the source and
destination in the policy.
02101 – Messages logged with a VIP (Virtual IP) incorrectly indicated the
VIP connection connected and disconnected repeatedly, indicating the
presence of a false positive even though the VIP connection sent
acknowledgment responses to the query. The messages displayed
continuously were:
VIP cannot be contacted.
VIP is now alive.