Juniper Networks 5XT Network Router User Manual


 
Juniper Networks NetScreen Release Notes
ScreenOS 5.0.0r9-FIPS P/N 093-1638-000, Rev. A Page 9 of 42
03132 – When using Juniper NetScreen-Remote to connect to a Juniper
NetScreen-500 dial-up VPN using the WebUI, the IKE Gateway
Configuration displays as user instead of user-group.
03128 – Mistakes occurred with (MIP) Mapped IP translation when a remote
shell used a secondary session initiated from the server for redirecting
standard error output from the console.
03095 – If the Juniper NetScreen-5XT autonegotiated its speed and duplex
settings with a Cisco 3550, the devices operated properly, but the connection
would fail if you manually set 100MBps - Full and 100MBps - Half for both
devices.
03092 – When the device was in transparent mode, it sometimes was unable
to download the latest anti-virus signatures.
03081 – An anti-virus parsing error slowed performance for HTTP sessions.
03078 – With a very large configuration, when you attempt to save a very
large configuration, the device sometimes generated false HA up-down
messages incorrectly indicating alternatively that the device disconnected
and connected.
03071 – If the first VIP (Virtual IP) in the VIP list did not have a service
defined for it, if you added a service to the second to fourth VIP in the list,
the VIP Summary Page displayed no data.
03068 – When you modified the IKE Phase 1 gateway name using the
WebUI, the primary device in an HA pair could not synchronize properly
with the backup device so that the backup device received the IKE gateway
name.
03058 – After you successfully updated a device with the latest configuration
in Security Manager, and then ran a Delta Configuration Summary
operation, the summary still displayed commands indicating that the update
did not successfully transfer all settings to the device.
03054 – The device did not update its ARP table because too many packets
queued up for the same ARP entry.
03042 – The serial interface on the device disappeared after you downgraded
from ScreenOS 5.0.0rx to a previous version with the Unlimited Number of
Users Version 2 key installed.
03025 – In certain situations, when a user authenticated using WebAUTH
with SecureID, and the user in the Auth table timed out, subsequent
attempts to authenticate failed.
03010 – In certain situations when you ping a Juniper NetScreen-5200-24FE
interface, an error condition occurred which sent out fragmented packets.
02988 – The ALG did not work for a custom-defined rsh (remote shell)
service.