Juniper Networks 5XT Network Router User Manual


 
Juniper Networks NetScreen Release Notes
ScreenOS 5.0.0r9-FIPS P/N 093-1638-000, Rev. A Page 8 of 42
03269 – The Juniper NetScreen-5GT incorrectly autonegotiated to 10MBps
half duplex after it had initially set itself to 10MBps full duplex.
03267 – The anti-virus feature had a problem handling the HTTP packets
because a web server inserted too many unnecessary white spaces in the
HTTP header.
03263 – When managing the device from the V1-untrust or V1-trust
interface using Manage IP, multiple sessions were created for each packet.
03261 – When you have two VPNs active between two devices, with outgoing
interfaces, after the VPN Monitor deactivated the tunnel after nine seconds,
and caused a failover to the secondary VPN, the device did not update the
session information.
03250 – A memory corruption caused the device to fail.
03243 – In an instance where the client on the Untrust side of the device
connected to a MIP that connected the server to the trust side, when an ASP
began the server, it used a zero-sized window, slowing down performance,
with the server sending back one character at a time.
03239 – When you performed an FTP transfer or email download that went
beyond the maximum bandwidth allocated in the traffic shaping feature,
VOIP calls experienced a lot of intermittent voice transmissions.
03235 – When you forcefully closed several PKA/RSA SSH sessions without
properly logging out first, the system randomly failed several times.
03232 – Under some conditions, an HA (High Availability) pair with a 5000-
M2 module installed failed. This occurred when the primary device had
4,000 sessions on it and the backup device had 100,000 sessions.
03205 – When running two Juniper NetScreen-5200-24FE systems in an HA
active-passive environment, the secondary path would fail and both devices
would assume the primary role after you unplugged the two HA links.
03203 – The device sometimes failed when it traversed the session table.
03178 – The device sometimes failed with high CPU and the full session
table due to session memory corruption.
03177 – Intermittent system failures occurred during an SNMP walk.
03152 – When running XAuth in the WebUI environment, the XAuth page
displays the CHAP fragment reassembly method selected by default.
03142 – When you sent 64 bytes of packets through a route-based VPN
between two Juniper NetScreen-5200 Series systems with an IXIA packet
analyzer device, the Security Association failed and the packets did not pass
through the IXIA device.
03136 – Gratuitous ARP packets sent out to broadcast the presence of a
device were blocked from being sent.