Juniper Networks M7i Network Router User Manual


 
CAUTION: To prevent damage to fiber-optic transceivers and fiber-optic cables,
observe the following precautions:
Do not leave a fiber-optic transceiver uncovered except when inserting or
removing cable. The safety plug keeps the port clean and prevents accidental
exposure to laser light.
Do not bend fiber-optic cable beyond the maximum bend radius. An arc smaller
than a few inches in diameter can damage the cable and cause problems that
are difficult to diagnose.
Do not let fiber-optic cable hang free from the connector.
Do not allow fastened loops of cable to dangle, which stresses the cable at the
fastening point.
1. Make sure you have the appropriate cable for the FIC or PIC.
2. If you are connecting to a FIC or PIC with removable transceivers, make sure
the transceiver is installed.
3. If the transceiver is covered by a rubber safety plug, remove the plug.
4. If the cable connector is covered by a rubber safety cap, remove the cap.
5. Insert the appropriate cable connector into the cable connector port on the FIC
or PIC faceplate.
6. Arrange the cable in the cable management system to prevent it from dislodging
or developing stress points. Secure the cable so that it is not supporting its own
weight as it hangs to the floor. Place excess cable out of the way in a neatly
coiled loop in the cable management system. Placing fasteners on the loop helps
to maintain its shape.
Step 5: Connect Ground and Power Cables
NOTE: Connect each power supply to a separate external power source.
The M7i router uses either AC or DC power supplies. Perform the appropriate
procedure for each power supply in your router.
Connect AC Power on page 10
Connect DC Power on page 11
Connect AC Power
1. Locate the power cords shipped with the router, which should have a plug
appropriate for your geographical location.
2. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and
connect the strap to one of the ESD points on the chassis.
10 Step 5: Connect Ground and Power Cables
M7i Internet Router Quick Start