Filter
Top Products
Using CLI Commands to Reset the Device
NetScreen-5000 Series 33
Notice that the listing contains aggregate1, an aggregate interface comprised of
ethernet2/1 and ethernet2/2. This aggregate interface runs with a throughput
rate of 2 Gbps. You can now bind the aggregate interface to a zone.
U
SING
CLI C
OMMANDS
TO
R
ESET
THE
D
EVICE
If you lose the admin password, you can use the following procedure to reset the
NetScreen-5000 Series device to its default settings. This destroys any existing
configurations, but restores access to the device.
To perform this operation, you need to make a console connection, as described in
“Establishing a Terminal Emulator Connection” on page 25.
1. At the login prompt, type the serial number of the NetScreen-5000 Series device.
2. At the password prompt, type the serial number again.
The following message appears:
!!! Lost Password Reset !!! You have initiated a command to reset the device to
factory defaults, clearing all current configuration, keys and settings. Would you
like to continue? y/[n]
Note: As with most other interfaces, you must assign the aggregate interface an
IP address so that other nodes on the network can reach it.
Warning: Resetting the NetScreen-5000 Series will delete all existing configuration
settings, and the firewall and VPN services will be rendered inoperative.
Note: By default the device recovery feature is enabled. You can disable it by entering the
following CLI command: unset admin device-reset.