Filter
Top Products
6
Installation
● To install the monitor on a shelf or any other suitable
surface using screws
You can install the monitor without protruding the stand bottom
plate by moving the stand bottom plate to the rear position.
CAUTION
● Lay the monitor on a cloth with the LCD panel facing down to
prevent the LCD panel from being damaged.
● After moving the stand bottom plate to the rear position, be sure
to attach the stand with commercially available screws.
1 Loosen the stand screws on the stand support and remove the
bottom plate.
Bottom plate
Stand support
2 Temporarily set the stand screws to screw holes “3” on the right
and left sides of the stand support.
● Tighten the temporarily set stand screws so that they protrude
from the screw holes by about 4 mm.
Screw holes “3”
3 Hook right and left recesses “A” onto the temporarily set screws in
the stand support.
Recesses “A”
4 Adjust the position so that the screw holes on the stand support
align with right and left screw holes “C” and “E” on the bottom
plate, tighten the two stand screws on one side (four screws on
both sides), and finally retighten the temporarily set screws to lock
the stand support and the bottom plate.
Screw holes “C” and “E”
5 Use no less than two commercially available screws (no less than
four screws on both sides) for the screw holes (10 – φ8) on the
stand bottom plate, to anchor the monitor. (Use screws having
enough holding strength and resistance against external force of
expected vibrations.)
10 – φ8
CAUTION
● It is very dangerous not to anchor the stand with screws as
this may cause not only breakage due to the monitor falling or
dropping, but also injury or electrical shock.
● To detach the stand
CAUTION
● Lay the monitor on a cloth with the LCD panel facing down to
prevent the LCD panel from being damaged.
Screw holes for stand
attachment
Attachment screws
Monitor
Stand body
● To install the stand
When attaching the stand to the monitor, insert the guides
of the stand into the guide holes on the monitor to place the
stand in the correct position. Then fix the stand firmly with the
attachment screws.
Screw holes for
stand attachment
Stand body
Guides
Guide holes
Stand support
Monitor
●
Do not rest your arm on the monitor or lean against the monitor.
● Do not touch the LCD panel when installing the monitor.
● Be sure to install the monitor securely to prevent the monitor from falling over, which may cause damage to the monitor or injury.
The illustration of the monitor
is of DT-E21L4.