Filter
Top Products
13
ENGLISH
WAVE FORM SETTING
Settings for the wave form monitor
Item To do Setting value
POSITION
Select the position of the wave form monitor. 1 (lower right), 2 (lower left), 3 (upper left),
4 (upper right)
GAIN
Adjust the gain level for the incoming wave form
data.
–10 – +10
OVER LEVEL
Select the over level for the incoming luminance
signals.
☞ “NOTE”
MARKING
Activates/deactivates the function to change the
color of a wave form when the signal exceeds the
limit specified on “LEVEL” (☞ below).
OFF, ON
LEVEL
Adjust the lower limit for the luminance signal 070 –109
AUTO OFF
Activates/deactivates the function to make the
wave form monitor indication go off automatically
15 minutes after displaying it.
ON, OFF
SYNC FUNCTION
Settings for the synchronization with signals
Item To do Setting value
NO SYNC ACTION
Select the screen status when no signal is
coming in.
OFF,
P.SAVE (power save mode),
GRAY B. (gray screen)
DELAY TIME
Select the period until the screen status
changes as selected in “NO SYNC ACTION”
after signals stop coming in.
30sec., 5min., 15min.
• When setting “NO SYNC ACTION” to “GRAY B.,” the screen color changes to gray and the power consumption
of the back light is saved by half.
Selecting “P.SAVE” (power save mode) saves more power consumption by turning off the back light.
Operation guide
Shows the buttons for each
operation.
Example of the wave form monitor
Ex.: When “MARKING” is set to “ON” and “LEVEL” is set to “080”
NOTE
• The wave which goes over the value set on “LEVEL”
is indicated in red.
Red
White
Start End
Video signal
• The menu automatically disappears in about 30 seconds after the previous operation.
• Some items may not appear on the menu depending on the input or the input signal.
• The items controlled by the MAKE system do not appear on the menu.
DT-V9L3D_EN.indd 13DT-V9L3D_EN.indd 13 09.7.23 10:34:00 AM09.7.23 10:34:00 AM