Filter
Top Products
4
Installation
CAUTION
• Do not rest your arm on the monitor or lean against the monitor.
• Do not touch the LCD panel when installing the monitor.
• Be sure to install the monitor securely to prevent the monitor from falling over, which may cause damage to the monitor
or injury.
When shipped from factory, the stand is attached to the monitor.
You can tilt the monitor from about 20° upward to about 10° downward.
CAUTION
• Be careful not to pinch your fingers in the gap between the monitor and the stand.
• When the stand is attached to the lower position (☞ page 5), you cannot tilt the monitor downward.
About 20°
About 10°
0°
• When the monitor is not
tilted (0°), the guidelines
align as illustrated.
Guidelines
Screw holes for higher position
7 To adjust the stand height
You can select the stand height according to your preference—higher position or lower position.
To change the stand height, change the position of the screw hole used for attaching the stand.
• When shipped from factory, the stand is attached to the higher position.
• Before adjusting the stand height, set the monitor angle to 0°.
CAUTION
• Lay the monitor on a cloth with the LCD panel facing down to prevent the LCD panel from being damaged.
• Depending on the type of external batteries, the stand cannot be attached or detached when the external battery is
attached on the monitor.
• When the stand is attached on the lower position, some types of external batteries cannot be attached to the monitor.
Screw holes for lower position
Guide holes (only for attaching
to the higher position)
Rear panel of the monitor
Higher position
Monitor
Attachment screws
Stand
DT-V9L3D_EN.indd 4DT-V9L3D_EN.indd 4 09.7.23 10:33:53 AM09.7.23 10:33:53 AM