Filter
Top Products
10
Menu Configuration—MAIN MENU
BACK LIGHT
Adjusts the brightness of the display.
SHARPNESS*
1, 2
Adjusts the sharpness of the picture.
CTI.*
1, 2
Adjusts the clearness of the outlines of the chrominance signal.
• This setting does not affect BW signals.
LTI.*
1, 2
Adjusts the clearness of the outlines of the luminance signal.
COLOR SYSTEM*
1
Selects the color system.
• If the picture is unstable with “AUTO,” select “NTSC” or “PAL.”
ASPECT*
1
Selects the aspect ratio.
sub menu POSI.
Selects the position of the picture adjustment bar and volume adjustment bar.
AUTO ADJUST*
3
Adjusts pictures of analog RGB signals automatically. Perform this adjustment when you input analog
RGB signals for the first time.
• Pictures may not be adjusted properly when you perform “AUTO ADJUST” with a picture of texts or
images on a black background. Perform “AUTO ADJUST” when an image is displayed fully on the
screen.
• After performing “AUTO ADJUST,” you can adjust each item manually.
Item To do Setting value
H.SIZE*
4
Adjust the horizontal picture size. –10 – 00 – +10
H.POSI.*
4
Adjust the horizontal picture position. 000 – 100
V.SIZE*
4
Adjust the vertical picture size. –10 – 00 – +10
V.POSI.*
4
Adjust the vertical picture position. 000 – 082*
5
DOT CLOCK*
4
Eliminates stripes or flickering by adjusting the both
settings.
000 – 100
CLOCK
PHASE*
4
000 – 063
*
1
Displayed only when VIDEO 1 or VIDEO 2 is selected for the input.
*
2
Memorized for each Picture Mode (☞ “ 7 PICTURE MODE button/lamp” on page 6).
*
3
Displayed only when RGB is selected for the input.
*
4
Memorized for each signal format. For some signals, the adjustment may not take effect.
*
5
The maximum value is different depending on the incoming signal format (“082” is an example for SXGA
signals).
Operation guide
Shows the buttons for each operation.
For the operation procedure, see page 7.
When VIDEO 1 or VIDEO 2 is selected for the input:
• The menu automatically disappears in about 30 seconds after the previous operation.
• Some items may not appear on the menu depending on the input or the input signal.
• The items controlled by the MAKE system do not appear on the menu.
Setting value: AUTO, NTSC, PAL
Setting value: 00 – 25
Setting value: 00 – 10
Setting value: OFF, NORMAL, HARD
Setting value: OFF, NORMAL, HARD
Setting value: 4:3, 16:9
Setting value: LOWER, UPPER
Selected Picture Mode
Select by pressing PICTURE MODE on the front
panel (☞ 7 on page 6). (Not displayed when “STD.” is
selected.)
Operation guide
Shows the buttons for each operation.
Operation guide
Shows the buttons for each operation.
Press
to perform “AUTO ADJUST.”
When RGB is selected for the input:
When DVI is selected for the input:
LMH191&171EA_EN.indd 10LMH191&171EA_EN.indd 10 08.7.8 5:40:24 PM08.7.8 5:40:24 PM