Filter
Top Products
English
|
13
Overhead View Guideline Adjustment
(Red Line Position Setting)
This item adjusts the position of the red line
displayed in the overhead view. The red line can be
used independently to set the reference line for the
vehicle parking position.
1 Select “OVERHEAD VIEW GUIDELINE
ADJUSTMENT (Red Line Position Setting)”.
2 Press the + or – button of the switch unit to
adjust the position of the red line.
By default, the red line is superimposed with the
yellow line that is closest to the vehicle. Move the
red line until the edge of your vehicle’s bumper.
3 After completing the adjustment, press the
view button.
4 Select [Next].
Advances to “SETTING COMPLETE”.
Finishing the Camera Setting
1 Press the + or – button of the switch unit to
select [Finish] and press the view button.
Camera ID Setting
When connecting two CMOS-300 units to a Kenwood
navigation system equipped etc. with the camera
control function, it is required to assign different
camera IDs to the 2 cameras. The camera IDs of both
cameras have been set to ID1 at the factory.
1 Press and hold the + button of the switch unit
for more than 2 seconds, and then press and
hold the – button for more than 2 seconds.
2 Press the + or – button of the switch unit
to select the camera ID, and press the view
button.
3 After setting, press the + or – button of the
switch unit to select [Finish] and press the view
button.