Kenwood DDX4070BT Computer Monitor User Manual


 
English 3
WARNINGS:
(To prevent accidents and damage)
DO NOT install any unit or wire any cable in
a location where;
– it may obstruct the steering wheel and
gearshift lever operations.
– it may obstruct the operation of safety
devices such as air bags.
– it may obstruct visibility.
DO NOT operate the unit while driving.
If you need to operate the unit while
driving, be sure to look around carefully.
The driver must not watch the monitor
while driving.
Cautions on the monitor:
The monitor built in this unit has been
produced with high precision, but it
may have some ineffective dots. This is
inevitable and is not considered defective.
Do not expose the monitor to direct
sunlight.
Do not operate the touch panel using a
ball-point pen or similar tool with the sharp
tip.
Press the buttons on the touch panel with
your finger directly (if you are wearing a
glove, take it off).
When the temperature is very cold or very
hot...
– Chemical changes occur inside, causing
malfunction.
– Pictures may not appear clearly or
may move slowly. Pictures may not
be synchronized with the sound or
picture quality may decline in such
environments.
For safety...
Do not raise the volume level too much,
as this will make driving dangerous by
blocking outside sounds, and may cause
hearing loss.
Stop the car before performing any
complicated operations.
Temperature inside the car...
If you have parked the car for a long time
in hot or cold weather, wait until the
temperature in the car becomes normal
before operating the unit.
How to reset your unit
DDX790/DDX770/DDX7070BT
Reset button
DDX470/DDX4070BT/DDX370/DDX3070
Reset button
If the unit fails to operate properly, press
the Reset button. The unit returns to factory
settings when the Reset button is pressed
(except the registered Bluetooth devices).
How to read this manual:
Illustrations of DDX770 are mainly used
for explanation.
This manual mainly explains operations
using the buttons on the monitor panel
and touch panel. For operations using the
remote controller (RC-DV340: supplied
only for DDX7070BT/DDX4070BT/
DDX3070
), page 66.
< > indicates the variable screens/
menus/operations/settings that appear
on the touch panel.
[ ] indicates the buttons on the touch
panel.
Indication language: English
indications are used for the purpose
of explanation. You can select the
indication language from the <Setup>
menu. ( page
52
)
Before use
The displays and panels shown in this
manual are examples used to provide
clear explanations of the operations. For
this reason, they may be different from the
actual displays or panels.
EN_GET0907-001A_KR.indb 3 12/11/13 10:13