Filter
Top Products
Chapter 6 : WINDOWS 200x / XP INSTALLATION
6.1 Operating System Supported
§ Windows 2K & Windows XP
§ Supported by Microsoft default driver. (Requires service pack from Microsoft Windows Update
website)
6.2 Verify windows has properly installed the device driver
§ Connect the device to PC via USB connection.
§ Turn ON the device. Windows will detect “NEW HARDWARE FOUND” and the Operating
System (OS) will automatically install the Mass Storage device driver. The Window OS will
initialize the Memory Card Reader as Removable drive and the hard disk as Local drive.
q Click on the My Computer icon by
right-click on the mouse.
q Select the Properties item.
q Choose the Device Manager
selection
q Double click on the Disk Drives
item
q And check the three INSTEP EzII
DRIVE have installed.
q Double click on the Storage
volumes item.
q And check the Generic volume
properly installed.
q Double click on the Universal serial
bus controller item.
q And check the USB Mass Storage
Device has installed.
§ Upon installation, you will notice 3 icons appear on the “My Computer” screen. Refer to the
section on “Create Master Boot Record on the new hard disk & Create Primary Partition Record
on the new hard disk” if user do not see the hard disk drive icon.
6.3 Troubleshoot
§ Click on the My Computer icon by right-click on the mouse.
§ Select the Properties item.
§ Choose the Device Manager selection
§ Double click the Universal serial bus controller and check the USB Mass
Storage Device is mark with an exclamation mark.
§ Click on the item mark with an exclamation mark and then click
Remove,Refresh.
§ The windows will prompt for device drive again.
User Manual
20