Filter
Top Products
Initialization
After plugging the DT4000-M device into a USB
port, if you receive the following warning message,
“Kingston DataTraveler requires an active
SafeConsole server to make it operational” (see
Figure 1.3), please contact your helpdesk or
SafeConsole Administrator.
The DT4000-M must be able to communicate with a
SafeConsole server in order to initialize prior to first
use and/or function properly after a device reset.
[Back to top]
Figure 1.3 – Warning Message
If you receive a connection window similar to the
one in Figure 1.4, ‘Connecting to <server>’, click
‘Yes’ to confirm ownership and responsibility for the
Kingston DataTraveler (DT4000-M.) This will
register your device on the SafeConsole server.
If you click ‘No’, you will receive the warning
message seen in Figure 1.3 and be required to
start the initialization process over. This can be
accomplished by doing one of the following:
Figure 1.4 – Confirm Registration
• Unplugging the DT4000-M device from your system and re-inserting it into the USB
port. (This will allow Windows to detect the device again and allow you restart the
initialization process.)
OR [Back to top]
• Browsing to the CD-ROM partition of the DT4000-M and re-launching the
DT4000M_Launcher.exe program application.
The window shown in Figure 1.5 will appear after
you click ‘Yes’ to register the DT4000-M on the
SafeConsole Management System. This indicates
that communication with the server has been
established.
Figure 1.5 – Connection Confirmed
Document No. 48000141-001.A01 DataTraveler
®
4000 – Managed Page 2 of 6