Kingston Technology KND2415TX Switch User Manual


 
Kingston Technology Company KND2415TX User’s Guide - Rev. A00
6 Hardware Installation
Power Switch
The AC Power switch turns the unit ON or OFF. If the PWR LED does not light
up once the unit has been turned on, try the procedures below (in the following
order):
1. Try a different AC power outlet.
2. Check the external fuse located at the back of unit (below the AC power
connector). If the fuse is blown, replace it with the spare fuse provided with
the unit. (See Fuse Compartment display in Figure 3-3)
3. The power supply may be defective. Return the unit for replacement.
WARNING: For safety reasons, DO NOT attempt to open and service the
unit. There are no user-serviceable components inside.
AC Power Connector
The Fast EtheRx dual-speed hubs use 100-240VAC internal power supplies.
Connect the AC power cord from the back of the unit to an AC electrical outlet.
Fuse
The Fast EtheRx dual-speed hub comes equipped with one external fuse and one
spare fuse. Both fuses are in a fuse holder located just below the AC power
connector on the back of the unit. Both fuses are rated 250V/2A max.
Fig. 3-3 Fuses
Fan Unit(s)
The Fast EtheRx dual-speed hubs use independent cooling fans for optimum air-
ow to safeguard the unit from unnecessary heat exposure.