Filter
Top Products
Rear Panel 7
KND2410TX User’s Guide - Rev. A01 Kingston Technology Company
Stack-In / Stack-Out Ports
Fig. 1-4 Stacking Configuration
The Fast EtheRx stackable hubs use stacking ports located on the back of the
unit to stack up to a maximum of four hubs, using any combination of the
KND810TX, KND1610TX, and KND2410TX models. Follow the directions
below on stacking these hubs together:
1. Power down the Fast EtheRx hub(s).
2. Locate the 50-pin shielded stacking cable included with your
package contents.
3. Plug one end of the cable into the port labeled, “Stack-Out”
on the first hub.
4. Plug the other end of the cable into the “Stack-In” port on the
second hub.
5. Repeat steps 2 through 4 for stacking up to a maximum of
four (4) hubs.
Kingston’s Stack-n-Play
™
feature offers greater scalabilty to add UTP ports
without the need to configure ID or termination switches. When configured as
a stack, the Fast EtheRx stackable hubs are recognized as a single unit on the
network. By stacking hubs together, you can expand the total number of UTP
ports up to 96 ports.
USE ONLY WITH A 250V FUSE
USE ONLY WITH A 250V FUSE
USE ONLY WITH A 250V FUSE