Kingston Technology KNE12TX/RS Switch User Manual


 
10 Hardware Installation
Kingston Technology Company KNE24TX/RS User’s Guide - Rev. A01
KNE100TX/RSC for SC connectors.
Stacking Fast EtheRx Hubs
The Fast EtheRx hubs use stacking ports located on the rear panel to stack up
to six hubs in any combination of 8-Port, 12-Port, or 24-Port models. Follow
the directions below to stack up to six hubs together:
1. Locate the 50-pin shielded stacking cable included with your
package contents.
2. Plug one end of the cable into the port labeled, “Out” on the first
hub.
3. Plug the other end of the cable into the “In” port on the second hub.
4. Connect the AC power cord to each hub, then flip the power switch
to turn on power to the unit.
5. Repeat the process to stack additional hubs up to a maximum of six
(6) hubs.
Figure 3 below illustrates the configuration for stacking six of the 12-port
model hubs, expanding the total number of UTP port connections from 12 to
72 UTP ports, while still being recognized as one single repeater unit on the
network. A maximum of six (6) Fast EtheRx hubs can be stacked in any
combination of 8-, 12-, and 24-port models.
100-240VAC / 50-6
OUT
IN
Stackable Module
100-240VAC / 50-6
OUT
IN
Stackable Module
100-240VAC / 50-6
OUT
IN
Stackable Module
100-240VAC / 50-60Hz 2.0A Max
PWR
OUT
IN
Stackable Module100FX Fiber Module
100-240VAC / 50-60Hz 2.0A Max
PWR
OUT
IN
Stackable Module100FX Fiber Module
100-240VAC / 50-60Hz 2.0A Max
PWR
OUT
IN
Stackable Module100FX Fiber Module
100-240VAC / 50-60Hz 2.0A Max
PWR
OUT
IN
Stackable Module100FX Fiber Module
100-240VAC / 50-60Hz 2.0A Max
PWR
OUT
IN
Stackable Module100FX Fiber Module
100-240VAC / 50-60Hz 2.0A Max
PWR
OUT
IN
Stackable Module100FX Fiber Module
Stack
up to
6 hubs
maximum
Fig. 3. Stacking Additional Hubs